82: Chapter 82 Smelting
When Jiang Yan awoke from his meditation, the light outside the window was already bright.
Sunlight leaked through the gaps in the window lattice, drawing several crooked, bright lines on the floor.
Dust slowly swirled within the pillars of light, each speck glittering like crushed silver powder.
Jiang Yan took that pale green Flying Sword out of his Storage Pouch.
The sword lay horizontally across his knees, cool to the touch.
Traces of Chen Feng's spiritual power still remained in the Wind Blade Restriction on the sword's body, emitting a very faint cyan halo in the morning light.
His Divine Sense probed into the interior of the sword, scanning it once.
Five Restrictions: Sharpness Restriction, Durability Restriction, Lightness Inscription, Wind Blade Restriction, and Armor Piercing Restriction.
The engraving technique was reasonably neat, the lines were clean, and there were no obvious chips at the turns.
However, the material ratio of the sword blank was problematic—too much Lightness Sand had been mixed into the spine of the sword, estimated to account for nearly twenty percent of the total weight.
Lightness Sand is light and brittle; if mixed in too little, the Flying Sword isn't fast enough, but if mixed in too much, the sword body becomes brittle and prone to chipping during head-on clashes.
The Artifact Refiner who crafted this Flying Sword likely pushed the ratio of Lightness Sand too high in pursuit of speed.
There was also a minute flaw in the angle of the Wind Blade Restriction circuit at the tip of the sword.
It wasn't an engraving error, but a problem with the design itself—the angle of the circuit's turn was too small. When utilized with full power, the flow of spiritual power to this point would create a weak vortex, affecting the speed and stability of the Sword Qi's condensation.
This flaw was imperceptible during ordinary use, but would accumulate and worsen during high-intensity, continuous sword strikes.
This sword could not be sold as is.
Chen Feng had been in Black Stone City for at least several years, and there were not a few people who knew him.
Once this sword appeared on the market in its original form, it would sooner or later be recognized by those close to him.
Although no one saw him kill Chen Feng, as for trouble, the less there was, the better.
He took the Artifact Refining furnace out of his Storage Pouch.
The dark silver, cylindrical furnace body made a dull thud when it landed on the table, much heavier than it appeared.
The red-gold patterns on the furnace walls, naturally formed after the flame gold seeped into the mithril lattice, glowed with a warm luster in the morning light, extending from the base of the furnace to its rim like the annual rings of an old tree.
The heat-storage layer inside the furnace belly still retained fire-attribute spiritual power accumulated from the last time it was used for Artifact Refining. It was reactivated with a light touch of his fingertip, and the entire furnace began to radiate a slight heat.
Several pieces of low-grade Materials were laid out one by one beside the furnace.
A small piece of Wind Crystal, the size of a fist, scavenged from Chen Feng's Storage Pouch.
Its quality was average, with a few minute cracks on the surface, but its attributes were pure, naturally having an affinity for wind-attribute spiritual power.
This item was worth about ten or so Spirit Stones on the market, just right for enhancing the Flying Sword's wind attribute.
Two fingernail-sized fragments of Lightness Sand, picked up near the nest of an Iron-Tailed Lizard in the Manghuang Mountains.
The surface of the sand grains was covered in dense, honeycomb-like pores, each as thick as a hair; they were natural carriers for the Lightness Inscription.
Holding them at his fingertips and looking toward the sunlight, the light was refracted into colorful spots as it passed through the pores.
There was also a small piece of mithril, only the size of a fingernail.
He activated the fire-gathering Restriction on the Artifact Refining furnace.
Pale cyan spiritual fire surged from his palm, enveloping the furnace body.
A ball of cyan-white flame rose within the furnace belly, swirling once before stabilizing, casting the entire guest room in flickering light and shadow.
The dancing shadows of the firelight were cast upon the curtains, like a giant butterfly flapping its wings.
The cyan Flying Sword was the first to be placed into the furnace.
The sword body gradually changed from pale cyan to crimson in the spiritual fire.
First the tip changed color, then the crimson spread inch by inch back along the sword spine, washing over the crossguard, washing over the hilt, until finally, the entire sword was burned through, transitioning from crimson to incandescent white.
A wisp of very faint cyan smoke drifted out from an invisible crack on the sword spine; it was the mark of Chen Feng's spiritual power remaining in the sword body, turning into cyan smoke in the spiritual fire.
The Wind Crystal followed closely, being placed into the furnace.
The brownish-green metal block slowly softened in the spiritual fire.
The melting point of Wind Crystal was lower than that of gold essence; it lasted only half a cup of tea's time in the spiritual fire before it began to deform.
First the edges and corners rounded, then the entire piece of metal collapsed, with thick, dark green liquid droplets seeping from the surface.
Under the envelopment of his Divine Sense, the droplets were guided to seep into the sword body—not infiltrating evenly, but embedded along both sides of the centerline of the sword spine, forming two extremely thin wind channels extending from the crossguard to the sword tip.
The Lightness Sand fragments were ground into fine powder.
The powder was filled into the spiritual power nodes at the connection point between the sword body and the hilt.
These nodes were the channels through which spiritual power was poured from the Cultivator's palm into the sword body. After filling them with the Lightness Sand powder, the conduction of spiritual power would be smoother, and the spiritual power consumed during utilization could be reduced by about ten percent.
The mithril was drawn into extremely fine threads.
The fingernail-sized silver-white metal softened into a semi-molten state in the spiritual fire. He used his Divine Sense to guide it, drawing it into silver threads as thick as a hair, spreading it along the grooves of the sword spine to form an extremely thin Qi-conducting layer.
Mithril had the best spiritual power conductivity among all first-tier Materials; this Qi-conducting layer could reconnect the circuits of the six Restrictions, ensuring that there was no longer any lag when spiritual power circulated between the Restrictions.
Re-engraving the Restrictions was the most demanding step.
Jiang Yan completely erased the original five Restrictions.
He used the spiritual power at his fingertips as an engraving knife to re-trace the lines.
As the engraving knife passed over the sword body, it made a very faint rustling sound, lighter than ants crawling across paper.
The depth of every cut was precise to three hair-widths, and the angle of every turn in the patterns was exact to the slightest degree.
The Sharpness Restriction traced along the sword edge, its patterns as fine as hair, forming a ring of minute serrated structures on the edge.
The Durability Restriction intertwined across the sword spine, with three horizontal lines and two vertical lines overlapping into a mesh, raising the impact resistance of the sword body by a notch.
The Lightness Inscription circled the hilt three times, with the spacing of each circle being exact.
The Wind Blade Restriction was laid out along the inner sides of the two wind channels, its patterns parallel to the wind channels; when the Wind Blade was activated, the spiritual power would first pass through the wind channels to accelerate before bursting forth.
The Armor Piercing Restriction converged into a cone shape at the tip of the sword, with the patterns spreading back from the tip, forming spirals in circles.
The Wind Manipulation Restriction—this was an additional one he added—was engraved in the very center of the sword spine, sandwiched between the wind channels and the Durability Restriction.
The pattern of this Restriction was completely different from the Lightness Inscription; the Lightness Inscription was for reducing the weight of the sword body, while the Wind Manipulation Restriction was for utilizing wind-attribute spiritual power to assist in flight, which could save about ten percent of spiritual power consumption when utilizing the sword.
Flying Swords with the Wind Manipulation Restriction were rare on the market because engraving this Restriction required a deep understanding of wind-attribute spiritual power, which ordinary first-tier Artifact Refiners simply could not do.
The moment the sixth Restriction was finished, all six Restriction patterns lit up simultaneously.
Pale cyan spiritual light surged from the hilt to the sword tip and then back to the hilt, flowing back and forth on the sword body for three cycles before slowly fading.
As the spiritual light flowed over each Restriction, the pattern of that Restriction would briefly light up—first Sharpness, then Durability, Lightness, Wind Blade, Armor Piercing, and finally Wind Manipulation.
The spiritual light of the six Restrictions intertwined, illuminating the entire Flying Sword as if it were a piece of glazed glass just taken out of the furnace fire.
The sword body hovered at the mouth of the furnace, vibrating slightly, and let out a clear, resonant chime.
It was not a sword hum, but a Restriction resonance—the six Restrictions were activated simultaneously under the infusion of spiritual power, and their respective spiritual power circuits overlapped and vibrated within the mithril Qi-conducting layer, producing a sound like flicking the edge of a crystal glass with a finger.
🔊 Text To Speech
Listen while reading